![]() ![]() This will reset your network protocols and open the system configuration. Skipping ahead, enter the following commands into an admin command prompt: ![]() Ensure your anti-virus/etc isn't blocking it - note this wouldn't be a block on GW2, but rather the file GW2 is downloading. If you're sure you've done the hosts file correctly, then your problem is caused by other software, or in very rare cases your ISP could cause it (which will likely require a VPN). If there's a problem, it'll fail or freeze while copying. If you're sure it's correct, look for Gw2.log where Gw2-64.exe is located and under Documents/Guild Wars 2.Īs a simple disk test, copy/paste Gw2-64.exe while it's stuck. A simple option to test is -diag to cause GW2 to start a test (you can cancel it) rather than the launcher. If it's not created, ensure the command line option has been set correctly. To open that folder, press WindowsKey R and open: %appdata%\Guild Wars 2 Look for it in the Guild Wars 2 folder under %appdata% (same place as Local.dat). The file should be created immediately on launch. Gw2.log will only be created if GW2 is launched with the -log option.
0 Comments
Leave a Reply. |